IK Foam Pro 12 Sprayer Reviews

An excellent product for those who want to do a prefoam or wash foam application but don't have a pressure washer. I used Bilt Hamber Touch-less in mine with the intermediate foam setting and the foam was very good, but a bit dry, so I will use the wet foam setting next time. You also use less product over a foam lance/pressure washer set up. I use a plug in tire pump to pressurize the canister, and attach it to the unit so I have constant pressure, and don't need to recharge a battery powered pump. The unit is solidly built, and will probably last a long time. Spare parts are also available if anything should need replacing.

The IK Foam Pro 12 Sprayer is an excellent item and puts out quite a bit of foam. The assembly was minimal and the added option to fill the sprayer with air from a compressor really works well. The sprayer hold's 8 liters or 2.1 gallons but you have to leave room for adding air. So the usable amount of product is somewhere between 1/2 and 3/4's. I filled it up with 1 gallon of soap and water mix and after adding the air I was able to go around the whole car (Audi A4) and still had about 3/4's of a gallon left. I only needed to charge it once and didn't have any air leaks.

I finally started using this along with optimum power clean and it works ok but I'm struggling with the water to product mixture, along with what tip to use. I've tried em all and it just kinda spits out and every now and then it'll spray like you'd expect. Any thoughts? I've swapped out the filters too. Thanks.

So far I like it. I wasn't sure how much product to put into it to do certain size vehicles, so I'm still learning how much to fill it. I wouldn't fill tank past half way so you can have room for air pressure. Otherwise it works great.

I wouldnt buy it again due to having a hard time sourcing filters for it. It's very well built but 3 days into using it I lost the filters and now sourcing them is really hard. This is good if you need it short term but haven't found replacement filters which means at some point I will just trash this unit.

All I can say is wow!!!! Using the air compressor to fill it is great idea , no more pumping by hand. I use it for APC pre-rinsing and I can go around the whole car in one shot without pumping.

It's a beast and awesome. I use this to spray a traffic film remover. It foams really well and clings amazingly. You get great foam for pumping it or using your air compressor. Highly recommend.

Well built and provides excellent foam. Works great for my degreaser to clean engines. Air compressor option to refill it is great option.

We use this daily with P&S brake buster... Works awesome.

Very well built product , great alternative to foam guns.

Works better than expected, great for water restrictions and even uses less chemicals. Instructions are a waste of time but trial and error method by the third project you got it.

Very happy with it. I think being able to use an air hose to fill the unit is a necessity. It takes too long to hand pump. Works very well though.

Fantastic product, being able to fill it with air is genius. Perfect for washing in heated garage in winter.

Well built. Multiple uses from foaming car shampoo to foaming traffic film remover, interior cleaner etc...

Excellent foamer, it does what is say. You can do a large SUV with 1 L so no need to mix more then that