NanoSkin Glide Reviews

There are multiple uses for Nanoskin Glide but I use it as a Clay Lubricant. It works well and does the job. It is also economical as I dilute it 10:1 as recommended. It also has a pleasant scent.

This works great. I used with a clay sponge and very happy with results.

This is one of a few different clay lubes that I buy when on sale. It does a better job than typical QDs or ONR and is economical. I have used clay lubes in the past that had a buttery consistency, and some that were too diluted or watery, but this one has a perfect consistency and lubricity, without being overly slick where the clay can't bite. Recommended.

I was using Optimum No Rinse as a clay lube for a while but I decided to use a dedicated product for claying this time around. Used a Nanoskin clay mitt and this was crazy slick and I love it. When I use up the gallon I mixed up with this bottle I'll definitely buy it again when I need it.

1st time I clawed my car I used this product and it seem to work as instructed, haven't try any other product so can't compare. But had no problems bar glided over surface.

I have used for the nanoskin and it lubes fine, but it does not work well to clean up the area once done. So, I have to use a different quick detailer that cleans up much better. It is pain to have to use two different bottles when a good QD, should be able to lube and clean up.

I run a small detail shop in Mathews Va, Driveway Details, we clay every car we detail and this product is a game changer. Great product.

I run a small detail shop in Mathews Va, Driveway Details, we clay every car we detail and this product is a game changer. Great product.

I used this as a lubricator for claying and it works wonderful with a great smell.

Works well with nanoskin mit when dilluted 10:1 with distilled water and applied with an old Windex bottle. I cannot say whether the nanoskin mit works as well as a clay bar. I never got very far with a clay bar because I don't have that much patience. I can say that the mit is a LOT less work. The surface feels smoother after just a few swipes of the mit.

I originally bought a bottle of the pre-mixed solution and loved it. When I ran out, I ordered the gallon size and mixed it myself. It did not work as well as the pre- mixed version. I tried tweaking the mixture ratio, and it did not work as good as the pre-mixed for me. I spent hours experimenting with the ratio, but ended up not really happy with the end result. I will use the rest for a clay lube, not a detailer like originally intended.

I initially intended to use this as lubricant for DI's 100g Fine Grade clay bar. Clay bar was useless as it stuck to the paint. I had diluted this 1:9 and even with repeated lubrication, the clay bar didn't work.

So I tossed out the clay and instead used the dilution as a quick detailer. Lots of slickness for sure. Going to have to wait until I pick up a new clay bar. Might just go for the nanoskin auto scrub mitt,

Decided to give this a shot due to the good things I have been hearing about it. I typically just use ONR diluted as clay lube and have never thought of using something else before now. Glide was noticeably more slick, and I really liked it! I diluted it 7:1 (even though you can dilute it at 10:1). I think this will be my new "go to" for clay lube.

Good stuff, a must have for the nanoskin pad. I dilute it 10:1, still plenty of slickness and becomes quite economical at that point. Easy to remove from paint as well.

This is a must for the NanoSkin scrub pad. Just dilute per instructions and spray away.