The Last Detail The Last Cut Compounding Glaze - 32 oz

• Heavy defect removal - Zero fillers
• Extended product work time
• Easy product removal
• High lubrication to reduce surface heat build-up
• Versatile - Compatible with Microfiber, Wool, and Foam pads

The Last Cut is designed by a detailer for detailers and body shop users. Versatility is key and this product gives its users full control over aggression/finishing ability based on pad choice. Its main purpose is to remove scratches and swirls while leaving a glossy finish on a light or dark colored painted/clear-coated surfaces. On harder paints, its one step capabilities can be explored. Best results are achieved using a Dual Action or Rotary Polisher. This Silicone free formula contains NO FILLERS; showing true results after use.

Shake well before use. Make sure the surface is clean, dry, and free of contaminants. Bonded contaminants should be removed using a clay bar or equivalent method. Do not use on surfaces that are excessively hot to the touch. TLC may be used in direct sunlight if necessary but product performance cannot be guaranteed. When using a dual-action polisher, apply three dime size amounts to a foam, microfiber or wool hook and loop pad and work on a 24"x24" area. The product abrasives are diminishing, therefore, it needs to be spread over the polishing area preferably with hand motion and not slow machine speeds. Paint correction speed will vary based on pad selection however speed #5 or #6 is generally preferred for defect removal. Work product into the paint using slow back and forth, up and down motions until product turns clear. When using with a high-speed rotary polisher, equip the machine with a foam or wool pad. Apply 4 dime size amounts to pad. Set RPMs at 1500 and use a slow back and forth motion until polish turns clear. Remove residue using a clean, dry microfiber towel. For best results, your choice of sealant can be applied for a long-lasting shine and protection.